ESD Safe Tronex Cutters & Pliers

Tronex is the original Manufacturer of the best cutters for many Brands. Please see the cross of Tronex to Excelta

Standard Cutters

Standard cutters, sometimes called diagonal cutters, have heads with simple geometry: oval or taper. Oval designs are stronger; taper designs permit greater access. Standard cutters with full relief have lower profiles than cutters with semi-relief. 80% of all applications for precision hand cutting tools are best met with a standard cutter.

Oval	Taper	Miniature Oval	Miniature Taper Relief	Large Oval	Extra Large Oval

 

Angulated Cutters

Most precision hand cutting tools have cutting edges at a 15 to 20 degree angle so that there is clearance for the operator's fingers on the handles. However a much greater angle may be desired when access to the object being cut is very limited or when the work area is very crowded. Tronex offers angulated cutters at different angles and with different cutting edge sizes to meet a wide variety of needs.

Miniature 50º	Small 50º	Large 50º	Large 50º Pointed	Pointed Small 70º	Miniature 90º

 

Tip Cutters

Tip cutters are cutting tools with long, narrow jaws that have small, exceptionally sharp edges for cutting at the very tip. All Tronex tip cutters have long jaws for extended reach. Some Tronex tip cutters have lower profiles or have ultra fine cutting tips.

Miniature High Relief	Small	Sub Miniature	Rugged

 

Fine Hard Wire - Class W Cutters

Miniature Oval	Miniature Taper Relief	50º Thin	50º Wide

Fine Hard Wire - Class T Cutters

Oval	Taper	50º

Other Cutters

90° Standoff	45° Standoff	Heavy Duty

Pliers

All Tronex plier models share two characteristics:

1. A superior jaw in design and craftmanship.

2. The bearing ring joint that is featured with all Tronex precision cutters.

Chain Nose	Chain Nose Short Jaw	Needle Nose	Round Nose	Round Nose Short Jaw	Flat Nose	Bent Nose

Previous page  |  Print page